Heating tie-rod ends
I am the owner of an equipment sales and service company called Best Equipment Solutions Today, Inc, out of Southern Illinois.  I saw the Autotron 3300-3 at a local body shop where I ad rececently sold an alignment system.  We were having trouble getting a frozen tie rod end loose on the rear of a car.  I mentioned if they had a torch, we could heat the assembly up and try to get it free that way.  The owner said he had something that he would like to try out instead.  He used this Autotron 3300-3 Induction Heating System to heat the tie rod assembly up and within seconds it moved freely.  That was enough to sell me on the additional use of this tool.
J. Niswonger
Southern Illinois

Large Dent Removal
We are using the Autotron for Body Repair.  I was pulling a big dent on a door with a suction cup, which the customer didn't want to do any extensive repair.  However, bigger dents usually have memory, in other words, it will pop back to where it was if you push it lightly.  I heated the panel with the Autotron and then pulled it.  The panel not only stayed in place, but it was a whole lot easier to pull out.
S. Leong
Best Choice Auto and Body
Dallas, TX

Amazed by the Autotron Technology
Our company is Ford, Land Rover, Mazda, and BMW importer in Latvia with extensive dealer network.  Furthermore, we belong to Inchape automotive group, which extends our network even further.While being at body training in Finland, we've seen Autotron 3300 Induction Heater in action and been amazed by its function.  Immediately we'd like to purchase some 5 units with accessories to fill our body shop network and get advantage of modern technology.
Thanks and regards,
Mihails Kvetnis
Aftersales Develpment Manager
Baltic Motors, Latvia